Removing Ice Dams: The Basics

 What is an ice dam?

Short answer: An ice dam is the ridge of ice that forms at the edge of a roof which prevents melting snow from draining as it should. The water that backs up behind the ice dam can leak into the home & cause damage to walls, floors, ceilings, insulation, & other areas. See a basic illustration of an ice dam below. Large ice damSmall ice dam.

Where do ice dams happen: Most ice dams occur on the lowest edge of your roof as described above. We frequently find them in other locations, however. Click here to see a drawing of usual ice dam locations. Study this diagram closely as it is frequently the case that ice dams can not be identified from the ground.

Anatomy of an Ice Dam

What causes ice dams?

Short answer: Roof ice & ice dams result from the escape of heat into the attic or roof space.  This heat builds up & eventually melts snow on the roof, which, as described above runs to the cold edge of the roof & forms an ice dam.  Factors such as ventilation, insulation, solar orientation, tree coverage, home architecture, snow cover & weather conditions all interact to determine ice dam activity on every home.  Because no two houses are the same, it is usual to have neighboring homes on two ends of the ice dam spectrum; one may have major leaking, while the other is virtually unaffected.

Watch this short video on What is an Ice Dam & Ice Dam Prevention.

Tips on preventing damage: Preventing damage from an ice dam is pretty straight forward. It’s all approximately being proactive. When you think you may have a problem, it’s time to call The Ice Dam Company. Don’t wait until ice dams are on the news or in the Star Tribune. If you do, you will have to wait in line to obtain your ice dam removed, which can sometimes be a matter of days or weeks.  It’s better to bite the bullet & address things before you have a real problem on your hands. Here are some usual forms of damage done by ice dams. Ouch.

Learn more on ice dam prevention.

Ice Dams: Fact vs. Fiction

There is a lot of misinformation out there on the topic of ice dams. Our goal here is to be the single definitive source for all things relating to ice dams. Towards that end, here are some usual misconceptions approximately ice dams, roof snow, roof ice & gutter ice removal.

Fact: Ice dams can occur with virtually no snow on your roof. It’s a question of ice accumulations. It takes very little actual moisture to form ice dams. Even a dusting of snow can create a problem. Of course it is most often the case the thick snow accumulations create ice dams more quickly.

Fiction: Gutters have something to do with ice dams. The truth is gutters have nothing whatsoever to do with ice dams. If your home is prone to ice dams you will obtain them either way. If you have gutters they will fill with ice & provide a foundation for the ice dam above. If you don’t have gutters, the ice dam simply builds on the cold edge of the roof. We provide ice dam removal for many homes each year that do not have gutters.

Fact: Gutter systems can be damaged by gutter ice. We see it every year. A section of otherwise fine gutter is either on the ground or hanging pathetically off the edge of the roof, filled with ice. Fresh water ice weighs approximately 60 pounds per cubic foot & gutters are not designed to tolerate that sort of load. See photo of gutter ice damaged by an ice dam.It’s significant to initiate gutter ice removal sooner, then later.

Fiction: When it comes to insulation, the more the better. Improperly insulated homes are just as offensive as under insulated homes when it comes to ice dams. & roof ice We have fixed countless offensive insulation jobs for this reason. Specifically, we frequently find insulation done in such a way as to inhibit proper ventilation. Moreover, if you don’t address air leakage into the attic or rafter spaces, all the insulation in the world won’t prevent ice dams.

Fact: You can see ice dams from the ground. Not always. It’s true that you can usually spot a monster very easily. You can see the two foot icicles & the little glacier on your gutter.  The sneaky ones are usually above skylights or in roof pan areas far out of sight. Sometimes ice dams grow up valleys & on top of dormers making it almost impossible to identify from the ground.

Fiction: Salt socks are a smart way to address ice dams. People use pantyhose, old socks & store-bought cloth tubes filled with a variety of ice-melting compounds for removing ice dams. Corrosive substances like rock salt, sodium chloride, calcium chloride, magnesium chloride & more to melt channels through their ice dams. Some compounds are better than others, yet all present risks you should keep in mind.  Some of the aforementioned chemicals affect the integrity or color of your roof, some are corrosive to the aluminum when gutter ice is removed this way, some are corrosive to valley metal & other flashings, some damage plant life as the water drains below.  You are rolling the dice when you go this route so be aware.

Fact: Ice should be removed by steam. Here is the skinny. We are roofers & have fixed hundreds of roofs that have been damaged by well-intentioned professionals with hammers, picks & hatchets in their pursuit of removing ice dams to assist their clients.  The damage we have found caused by the less-than-professional souls is almost comical if it wasn’t so serious.  In our years we have seen jobs with picks & hammers where removing ice dams was done successfully.  It get’s down to a question of risk management.  We strongly advise against the hack-a-teer approach even if it is a little cheaper. Roof Ice & Gutter Ice should always be removed with rock salt or warm water.

Fiction: Ice dams need to be thick to cause a problem. Ice dams as thin as one inch can cause huge problems. A satisfactory general rule is that the steeper your roof, the thicker the ice dam has to be to cause problems. On lower pitched roofs even a thin ice dam can hurt.

Fact: The leaking caused by ice dams may not show up right away. It would be nice if water stains or mold manifested immediately upon entering your home yet it simply does not work that way.  Often the water that ice dams push into homes travels around wall & ceiling cavities, trapped by vapor barriers & other materials until it finds the path of least resistance to escape. By the time you see water inside, it’s usually been there for a while.

GD Star Rating
loading...
GD Star Rating
loading...

What are Seamless Gutters?

seamless-rain-guttersSeamless gutters are rain gutters that are cut from a preformed roll of composite metal. A rain gutter is a narrow trough that is attached to the outer edge of the roof to collect water & redirect it away from the building. Rain gutters are moreover called eaves troughs or eaves channel guttering.

  Rain gutters are an significant part of every roofing system. Redirecting the water off the roof reduces the erosion of soil at the base of the building, which weakens the foundation over time. Rainwater can be redirected into a water collection system, or diverted to specific locations with the use of downspouts.
Seamless gutters are a marketing term used to describe a specific method of rain gutter installation. These gutters have less seams & possible leakage points than other rain gutters, as they are formed from one continuous roll. Traditional gutters use aluminum pieces, which are attached on site & have visible seams.
To install seamless gutters, you must hire a Gutter Installer who offers this product. It is very usual in North America & available from a wide range of Gutter Installation companies. It is possible to purchase or install seamless gutters yourself. To see residential rain gutter types

If you are thinking approximately installing seamless gutters, make a list of your requirements. Determine the color of the gutters & the total length required. The gutters can be the same color as the roof or can coordinate with the other trim on the building.

When selecting a seamless gutter contractor, ask for a written quotation. The quotation should provide detailed pricing for the materials & installation labor. Obtain quotes from at least three different Installers to ensure you obtain the best price. Contact us for your free quote!

Ask for & check at least three references from prior customers before selecting a seamless gutter contractor. Ask the references if the work was completed on time, & their satisfaction with the quality of work. Take the time to visit the references & inspect the quality of the installation before selecting a contractor.

When the seamless gutter contractor arrives, they will have a Gutter machine inside a truck which contains a roll of metal in the selected color. The seamless gutter is formed on site from this roll. The gutter is then installed onto your fascia.

At each corner, the seamless gutter is cut just enough to allow the material to create a perpendicular corner. These cuts are then sealed during the installation process. The seal can be created on the inside of the gutter to provide a visually appealing appearance.

The installation staff work their way around the perimeter of the roof, attaching the seamless gutter as they go. Downspouts are usually installed at the end of the process. The downspouts are used to allow the water collected in the rain gutter to run off the roof to another location. For more information please contact us.

GD Star Rating
loading...
GD Star Rating
loading...

Special Coupons – Unlisted secret page:)

GD Star Rating
loading...
GD Star Rating
loading...