How to Fix a Loose or Sagging Gutter
If a gutter sags too much, it looks unsightly, & if the sag is in the wrong direction, water collects, giving mosquitoes a breeding ground & creating leaks. It’s standard to pitch gutters 1/16 inch per foot (2 mm per 30 cm) toward the nearest downspout, yet even a level gutter will drain. Assuming that the spikes, brackets or hangers are installed correctly, most commonly a gutter sags due to ice & snow damage or because a ladder has bent or dislodged its supports.
Instructions
If the gutter is supported by spikes (see A)
1. Straighten a bent spike by pushing up on the gutter at that location with a pry bar (you’ll likely need a ladder to reach it); or remove a nailed gutter spike for replacement by locking the head of the spike firmly in a pair of locking pliers, then tapping the side of the jaws with a hammer to pull the spike out.
2. Replace a spike that has fallen out or been removed with a threaded gutter spike. For a tighter fit, press a few wood slivers coated with exterior adhesive or epoxy into the nail hole first, this is for the do it your self. Although It is highly recommended that gutter with these types of hanging systems be rehung with reinforced inside hidden hangers with screw.
If the gutter is supported by hangers or brackets
1. Remove the gutter by unclipping the brackets & disconnecting it from the downspout(s). This is unquestionably a job for two or more people.
2. Replace the damaged bracket. Fill the old screw holes with caulk or exterior putty & let dry. Install the new bracket at approximately the same height & position as the old one. Repeat as needed for other brackets & tighten any loose screws before reinstalling the gutter.
If the gutter is supported by hangers or straps (see C)
1. If the strap is bent down, press down on it approximately 1 inch (2.5 cm) up the roof from the edge of the shingle it lies under, or from the surface to which it’s nailed. Then pull up just below the point of the bend.
2. If the bracket has pulled out of the roof or needs replacing, & the roofing is asphalt shingles, disconnect the bracket from the gutter & carefully pry up the shingle to remove the nails (or screws), or drive new fasteners through the strap into the roof recommend screws.
If the gutter is supported by concealed brackets
1. Remove the mounting screw to replace a damaged bracket.
loading...
loading...